Posts tagged location camera

CIRCUS: Location Sound

0

Another day, another circus Session this time we were learning about location sound. this is what i wrote about it for my Circus Report:

Locations sound works hand in hand with location camera’s providing additional sound capabilities to the single camera, for example an interview situation that required two personal mic’s could be mixed together before being fed to the camera as stereo or mono line level mix. Location mixers often have 2-4 inputs and can either mix in stereo or dual mono. Location mixers normally have better Microphone pre-amps than Camera’s, which in turn provides better sound quality, as the mixer is outputting at line level (0db) and the camera won’t apply any more amplification to the signal.

Some microphones require batteries or phantom power (+48v) to operate; these mic’s are a form of capacitor mic’s are much more sensitive than standard dynamic mic’s that don’t require power to operate. Most cameras and mixers can supply phantom power to these microphones.

When setting up for a shoot, you can use the tone that the mixer is supplying to the camera to help setup the record levels on the camera. Tone should be set just below the 0db mark as this allows some “head room” before the camera starts to clip the signal should you go above the tone volume.

CIRCUS: Location Camera

0

Another day, Another Operational skill, this time we were learning about Location Camera’s which is also know as Electronic News Gathering (ENG), which is also know as Personal Single Camera (PSC). This type of shooting is completely different to studio work, and requires a different mindset, for example with PSC you have to remember to add 30-seconds of Bars & Tone to the beginning of every tape you shoot with. Another thing before every shoot, is its best to check the back focus and time code is set-up correctly.

Without Time Code, editing the shot footage, is near impossible, especially when you are trying to sync up two different shots of the same pice of action up. For theses sorts of cuts to be smooth, the Time Code also needs to be synced between all the cameras that are recording.

Working with Rolly today has been interesting and light hearted session, we used a simple interview set-up to practice recoding to a Location Camera, for this simple shoot we teamed up with the location Sound Group.

Go to Top